ALM-173-R1 Module Configuration

Configure Modbus settings, 17 digital inputs, 3 relays, 4 buttons, 4 LEDs and alarm modes via Web Serial.

Connection: Disconnected

Bus: —

Model: —

FW: —

WebConfig: —

Modbus ID: —

Baud: —

Armed

Entry

Exit

Tamper

Device Setup

Serial connection and Modbus addressing.

Step 1

Modbus Address

Use a unique address per device on the bus.

Baud Rate

Must match your controller UART settings.

Communication messages and status updates.

Live alarm groups and per-group latch modes.

Any Alarm

Group 1

Group 2

Group 3

Mode – Group 1

Mode – Group 2

Mode – Group 3

Entry/exit delays and zone types (Instant / Delayed / 24h-Tamper) apply only when local arming is enabled below.

Local arming enabled

Entry delay (s)

Exit delay (s)

Local arming is optional; full Home/Away/Night modes and codes live in Home Assistant.

Configure enable, invert, alarm group, and zone type per input. Latched badge shows per-zone alarm memory (when local arming is on).

Configure enable, invert, alarm group mapping, power-on policy, and bell cut-off timeout.

Map physical buttons to acknowledge or override actions.

Configure indicator behavior for alarm and override states.